Gas flame acceleration in long ducts

In many practical situations, a flame may propagate along a pipe, accelerate and perhaps transform into a devastating detonation. This phenomenology has been known, more or less qualitatively, for a long time and mitigation techniques were proposed to try and avoid this occurrence (flame arresters, vents,...). A number of parameters need to be known and in particular the “distance to detonation” and more generally the flame acceleration characteristic scales. Very often, the ratio between the detonation run-up distance and the pipe diameter is used without any strong justification other that using a non-dimensional parameter (L/D). In this paper, novel experimental evidence is presented on the basis of relatively large scale experiments using 10 cm and 25 cm inner diameter duct with a length between 7 and 40 m. Homogeneous C₂H₄-air, CH₄-air, C₃H₈-air and H₂-air mixtures were used and different ignition sources. The interpretation suggests that the self-acceleration mechanism of the flame may be much better represented by flame instabilities than by turbulence build-up. One consequence would be that the maximum flame velocity and, following, the maximum explosion overpressure, would be rather linked with the run-up distance than with the L/D ratio.     

A dual-sensor-based method to recognize pipeline leakage and interference signals

During the detection of pipeline leakages, false alarms of leak detection could be markedly reduced if the interference signals resulting from pressure regulating, pump regulating or valve movements could be accurately distinguished. A digital recognition method for interference signals and leakage signals based on a dual-sensor system is proposed in this paper. It is demonstrated that the direction of the signal can be recognized by a cross-correlation calculation between two signals from the dual-sensor, one of which undergoes forward linear interpolation and backward linear interpolation. Based on this theory, the interference signal and the leak signal can be discriminated exactly, and the distance between the two sensors in the dual-sensor system can be considerably reduced without needing to increase the sampling frequency. The monotonicity of the cross-correlation function is demonstrated, and a fast discrimination algorithm based on a binary extreme search method, which decreases the computational load and maintains global optimization, is also proposed. A pre-processing method of the actual signal is proposed to decrease the identity requirement for the two sensors in a dual-sensor system. In the experiment based on artificial signals, the proposed discrimination algorithm could achieve accurate recognition of the abnormal signal, and as such, the theory and application of pipeline leak detection based on dual-sensor systems are extended.     

Spatial allocation of material flow analysis in residential developments: a case study of Kildare County,Ireland

Studies of urban metabolism provide important insights for environmental management of cities, but are not widely used in planning practice due to a mismatch of data scale and coverage. This paper introduces the Spatial Allocation of Material Flow Analysis (SAMFA) model as a potential decision support tool aimed as a contribution to overcome some of these difficulties and describes its pilot use at the county level in the Republic of Ireland. The results suggest that SAMFA is capable of identifying hotspots of higher material and energy use to support targeted planning initiatives, while its ability to visualise different policy scenarios supports more effective multi-stakeholder engagement. The paper evaluates this pilot use and sets out how this model can act as an analytical platform for the industrial ecology–spatial planning nexus.     

长江重庆段表层水体中多环芳烃的分布及来源分析

采集了长江重庆段干流以及重要支流共7个断面的表层水样,采用液相色谱法分析15种优先控制的多环芳烃(PAHs).结果表明,水体中总PAHs浓度范围为6.44—109.39 ng·L-1,平均值为41.83 ng·L-1.在5个断面水体中检出苯并(a)芘,浓度为0.05—1.32 ng·L-1,低于我国地表水标准限值(2.8 ng·L-1).长江重庆段的PAHs浓度水平低于大部分国内其他河流,与国外一些河流的浓度水平相当.PAHs组成以中低环PAHs(3环和4环)为主,平均比例分别为55.7%和38.8%,高环PAHs(5环和6环)含量较低,分别占3.6%和1.9%.示踪PAHs比值法结果显示长江重庆段表层水体PAHs主要来源于石化产品的泄漏污染.     

江西钨矿周边土壤重金属生态风险评价:不同评价方法的比较

对江西省大余县某钨矿区周边的农田土壤进行调查分析,并采用不同的方法对土壤进行评价,结果表明,土壤As、Pb、Zn、Cu和Ni的含量范围分别为15.33—154.65 mg·kg-1、156.29—346.98 mg·kg-1、47.73—277.72 mg·kg-1、19.06—210.24 mg·kg-1和12.00—35.11 mg·kg-1,一些土壤样点的As、Pb、Zn和Cu含量已超过国家土壤环境质量二级标准.利用地累积指数法对土壤进行评价,结果表明土壤均受到As、Pb、Zn、Cu和Ni不同程度的污染;根据CPI(综合污染指数)评价标准,65.7%的土壤处于污染状态;利用TCLP法对土壤生态风险进行评价,结果显示所有土壤并未受到重金属的污染,以内梅罗综合污染指数法对土壤进行综合评价,结果表明该农田土壤重金属生态风险处于安全范围;以潜在生态危害指数法评价,发现Pb、As和Cu达到或超过中等生态风险的样点分别占37.14%、25.72%和2.86%,其他重金属污染风险均属轻微以下.不同评价方法得出的评价结果有差异,人们在评价重金属污染土壤时要根据评价的目的慎重选择合适的评价方法.     

近红外长余辉纳米颗粒经小鼠眼部暴露后体内分布和代谢情况

为了研究纳米颗粒通过眼部暴露后进入体内的路径及在体内的分布和代谢情况,实验采用近红外长余辉纳米探针作为示踪剂,对小鼠进行眼部暴露,随后利用活体成像技术观察其进入小鼠体内的过程及分布情况,于暴露第4天收集代谢产物,第7天取重要脏器和血液,并检测纳米探针的存在情况.结果显示纳米探针可由眼经口腔进入胃肠道中,并且纳米颗粒暴露4天后在小鼠的粪便中检测到强荧光信号,而尿液中的荧光信号较弱,暴露7 d后在小鼠的眼睑结膜、胃及眼球中检测到强荧光信号,而其余器官的荧光信号较弱.这表明通过眼部暴露后,纳米颗粒主要分布在眼和消化系统中,最后大部分经消化系统代谢.     

药品和个人护理用品在固体基底中的检测方法和分布现状

药品和个人护理用品(Pharmaceuticals and personal care products,PPCPs)在环境中广泛存在,威胁生态环境和人类健康,受到越来越多的关注.本文综述了固体基底中PPCPs的检测方法,总结了国内外污泥、土壤、沉积物等基底中PPCPs的污染现状,并对PPCPs的进一步研究进行了展望.结果表明,PPCPs的检测方法朝多样化和趋优化的方向发展.污泥样品中PPCPs种类多、浓度高(μg·kg-1—mg·kg-1),土壤和沉积物中虽然浓度不高,但是总量不可小觑.目前,固体基底中的PPCPs还需要更全面和更广泛的研究.     

Fenton法和类Fenton法降解土壤中的二苯砷酸

本文对Fenton法与类Fenton法降解土壤中的二苯砷酸(diphenylarsinic acid,DPAA)进行了研究.考察了H2O2投加量和催化剂种类(Fe2+/Fe3+)对红壤及黑土中DPAA降解效果的影响,并采用高效液相色谱-质谱联用法(HPLC-MS/MS)对降解中间产物进行了初步鉴定.结果显示,针对红壤与黑土分别采用类Fenton法与Fenton法,在H2O2投加浓度为1 mol·L-1,含铁催化剂浓度为0.25 mol·L-1,土水比为1∶3,反应时间为1h的条件下,红壤及黑土中DPAA的降解率均可达到65%以上.HPLC-MS/MS的分析结果表明,DPAA可脱苯环形成降解产物苯砷酸(phenylarsinic acid,PAA),而PAA进一步氧化生成无机砷,这可能是Fenton/类Fenton法降解DPAA的途径之一.     

微孔曝气与覆盖对城市重污染河道底泥磷形态分布及释放过程的影响

采用自行研发的泥-水界面微孔曝气系统,开展了底泥表面曝气和覆盖对城市重污染河道底泥磷释放及形态分布规律的影响研究.结果表明,微孔曝气能够有效提高上覆水的溶解氧(DO)和沉积物的氧化还原电位(Eh),能够将泥-水界面Eh维持在-100 m V左右,DO提高到6 mg·L-1以上.与对照比较,原位覆盖处理的上覆水DO和Eh有一定提高,但仍明显低于微孔曝气处理.与对照相比较,微孔曝气处理均有效降低上覆水中总磷(TP)和溶解性正磷酸盐(PO3-4)的含量.试验结束时,微孔曝气(A)和微孔曝气+原位覆盖处理(A+C)上覆水中TP含量由初始的0.201 mg·L-1分别降至0.062 mg·L-1和0.050 mg·L-1;上覆水中PO3-4含量由0.086 mg·L-1和0.078 mg·L-1分别降至0.026 mg·L-1和0.023 mg·L-1.与对照相比,微孔曝气处理明显降低了底泥间隙水中TP的浓度,在整个培养期间,其TP含量平均下降38.8%(A)和47.9%(A+C).底泥原位覆盖处理对抑制泥-水界面磷释放能力要弱于微孔曝气处理,而且在试验后期(50 d),上覆水中TP和PO3-4的含量均有所反弹.不管有无覆盖,泥-水界面微孔曝气处理均显著改变了表层底泥磷形态分布特征,显著降低了底泥中铁铝结合态磷(Fe/Al-P)组分比例,而钙结合态磷(Ca-P)含量比例却出现明显增加.单一的表面覆盖处理对底泥磷形态分布特征没有显著影响(P0.05).研究表明,与单一的处理效果相比较,泥-水界面纳米微孔曝气处理,并结合底泥原位覆盖,更有利于抑制城市重污染河道泥-水界面中磷的释放风险.     

太原市土壤重金属污染空间分布及评价

以太原市土壤作为研究对象,系统研究了太原市城市土壤及工业区土壤中Cr、Ni、Cu、Zn、As、Cd、Pb的污染水平和分布,并对污染状况进行了评价.研究表明,太原市土壤中重金属的含量分别为Cr:35.35—848.80mg·kg-1,Ni:4.00—99.57 mg·kg-1,Cu:4.89—266.99 mg·kg-1,Zn:45.16—677.01 mg·kg-1,As:0.66—35.46 mg·kg-1,Cd:nd—1.00 mg·kg-1,Pb:15.61—1240.41 mg·kg-1.其中城市土壤重金属含量较低,工业区土壤重金属含量较高,受到多种重金属的复合污染.以土壤环境质量国家二级标准值作为评价标准,用单项污染指数和综合污染指数对太原市土壤重金属污染进行评价,结果显示太原市大部分城市土壤未受7种重金属污染,只有6.7%的地区处于轻污染水平;工业区土壤污染严重,污染程度从高至低为化工厂(重污染)热电厂(重污染)化肥厂(重污染)第一电厂(中度污染)建筑工地(中度污染)焦化厂(轻污染).7种重金属在太原市土壤中的空间分布规律不同,且均与工业区分布相关,工业区是太原城市土壤重金属污染的重要来源.